Dan L Clark
Member
- Messages
- 2
I am new to this forum. Nice site. I am about ready to pull the trigger on a cyclone and would like your opinion / counsel.
Small shop, 10" cab ts, jointer, planer, bs, lathe, 10" csms. I have 6" underslab piping.
I have researched building my own, don't think that will work.
Questions I have, is a 2HP with 12" impeller big enough (1000 cfm), or should I go to the 2.5 hp with 14" impeller?
Thanks in advance for your response.
Dan
Small shop, 10" cab ts, jointer, planer, bs, lathe, 10" csms. I have 6" underslab piping.
I have researched building my own, don't think that will work.
Questions I have, is a 2HP with 12" impeller big enough (1000 cfm), or should I go to the 2.5 hp with 14" impeller?
Thanks in advance for your response.
Dan