glenn bradley
Member
- Messages
- 11,558
- Location
- SoCal
I mentioned in passing awhile back that I'd picked up a PRL during the last email sale. I was going to wait till the current project was complete before installing it. I didn't have enough time tonight to work on the next phase of the project so I went ahead.
The wrenches reach easily from above. The little $16 Costco lithium screwdriver is my "high speed" adjuster. The old plate is in the background.
The 5625 looks so small in this thing.
I re-reinforced the lip of the plate hole. the 5625 is heavy enough but in the PRL it is a pretty good load.
The paper shims were for reference; I replaced them with foil tape.
The wrenches reach easily from above. The little $16 Costco lithium screwdriver is my "high speed" adjuster. The old plate is in the background.
The 5625 looks so small in this thing.
I re-reinforced the lip of the plate hole. the 5625 is heavy enough but in the PRL it is a pretty good load.
The paper shims were for reference; I replaced them with foil tape.