Bill Antonacchio
Member
- Messages
- 187
- Location
- Palm Beach Gardens, Florida
Hi All,
I am trying to get time to build a new workbench and have a few questions related to that end.
David Marks, on DIY WoodWorks repeats which I watch for the little extras you can catch with repeated watching, has a router built into the side of his tablesaw and uses the fence for both. My question is how does he remove the router easily to change bits and adjust the bit?
On his workbench it looks like he uses a Record type vise with a large wood frame to operate like a twin vise would work.
I know that several forum members have taken instruction from David and I was hoping someone could shed some light on these questions.
I am trying to get time to build a new workbench and have a few questions related to that end.
David Marks, on DIY WoodWorks repeats which I watch for the little extras you can catch with repeated watching, has a router built into the side of his tablesaw and uses the fence for both. My question is how does he remove the router easily to change bits and adjust the bit?
On his workbench it looks like he uses a Record type vise with a large wood frame to operate like a twin vise would work.
I know that several forum members have taken instruction from David and I was hoping someone could shed some light on these questions.