Russ Massery
Member
- Messages
- 104
- Location
- Northwest Indiana
Hello All, I've been away for awhile mainly My job has kept busy not allowing for shop time. I was able to work on these a little in the spring. But it got busy again. So over the last couple of weekend I've been able to get back at it. To start My wood supplier couldn't get enough 8/4 maple I needed for the legs. So after some thought I came up with the idea of laminating strips instead of a solid piece. The table I made for these chairs have walnut accents. So I went with the idea of putting a thin strip of walnut in the middle. So here's a couple of pic's of the glue up and the legs themselves after shaping. I bandsawed them out the attached a template with double faced tape. Then cut them out using a patten cutting bit on the router table.
Attachments
Last edited: