Jerry Palmer
Member
- Messages
- 317
- Location
- Cedar Park, TX
I'd been thinking of getting one of these for a while, but the price was just real hard to justify. Well, a fella on another forum had bought one, started assembling it, then changed his mind and decided to go with something else. So he had it listed in the swap and sell and I got it for significantly less than retail.
Since I don't have space for a stand alone router table, I use a router table extension on the table saw. Originally set it up using bolts through the shop built wood table area, but that was a PITA to set up and take down. With it mounted to the board shown, and with the table beneath marked for proper location, it takes only a couple minutes to set up or take down.
My first shot at half blind DTs with it came out pretty good.
Since I don't have space for a stand alone router table, I use a router table extension on the table saw. Originally set it up using bolts through the shop built wood table area, but that was a PITA to set up and take down. With it mounted to the board shown, and with the table beneath marked for proper location, it takes only a couple minutes to set up or take down.
My first shot at half blind DTs with it came out pretty good.