glenn bradley
Member
- Messages
- 11,516
- Location
- SoCal
Moving right along (finally). Here's a couple side assemblies, shelf and rear apron. Note the machining for the fig-8 connectors and a spanning brace (more on that in a sec).
All joints are pegged tenons. The shelf is a pegged through tenon and is not glued.
Hang with me a moment, I'll get there . . .
I wanted the drawer front to echo the side and rear aprons in appearance so that meant no frame at the drawer front. I added a spanning brace that will work along with the shelf to keep thing correct over time.
Square, square, square . . . keepin' it square.
Gotta go do the other one before I lose momentum.
All joints are pegged tenons. The shelf is a pegged through tenon and is not glued.
Hang with me a moment, I'll get there . . .
I wanted the drawer front to echo the side and rear aprons in appearance so that meant no frame at the drawer front. I added a spanning brace that will work along with the shelf to keep thing correct over time.
Square, square, square . . . keepin' it square.
Gotta go do the other one before I lose momentum.
Last edited: