Dan Mosley
Member
- Messages
- 1,169
- Location
- Palm Springs, Ca
I put a new motor on the table saw i had - 1 1/2hp, 220v and got it working today. I pluged it into the the 220 outlet i have in the garage for the dryer (same one im using for my Jet lathe) and it works great for about 30 seconds and then trips the breaker in the electrical panel. However, it never trips the breaker when im using my lathe.....
Anybody got a thought on this.........thanks Dan
Anybody got a thought on this.........thanks Dan
Attachments
Last edited: