Results 1 to 2 of 2

Thread: Chip Carving

  1. #1
    Join Date
    Nov 2008
    Southern Indiana

    Chip Carving

    I had fun with this. I do quite a bit of chipcarving straight lines but doing these round edges were interesting. I threw the frame around it to kind of give it a lodge look.
    Last edited by Donald Stonecipher; 12-09-2008 at 09:03 PM.

  2. #2
    Join Date
    Oct 2006
    ABQ NM
    Hard to see the carving because the picture is so small. If possible, can you re-upload it at a bigger size, say 800 x 600 pixels? If it'll help, there's a picture resizing and posting tutorial here:

    There's also another simple resizer discussed here:

    Looking forward to seeing the carving.
    When the going gets weird, the weird turn pro. - Hunter S. Thompson
    When the weird get going, they start their own forum. - Vaughn McMillan

Similar Threads

  1. Replies: 4
    Last Post: 05-28-2015, 05:41 PM
  2. chip cleanup
    By dave worrall in forum General Woodturning Q&A
    Replies: 10
    Last Post: 12-17-2014, 01:21 PM
  3. Chip Carving
    By gary doby in forum General Woodworking Q&A
    Replies: 10
    Last Post: 03-31-2009, 01:43 PM
  4. Chip Carving
    By Donald Stonecipher in forum Handtool Project Showcase
    Replies: 9
    Last Post: 12-03-2008, 02:19 AM
  5. Some Notes on Carving Tools for "Carving for Turning"
    By Mike Henderson in forum Lathe Project Showcase
    Replies: 15
    Last Post: 05-02-2008, 07:29 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts