Chris Mire
Member
- Messages
- 945
- Location
- Southern Louisiana
i was using this stuff to put some seal coats on a few items for the house. well it was quite cool and windy this weekend and hence it seems it was taking longer to cure. the can recommends 1 hours before resanding and second coat. so i waited 2, when i went to sand with a fine sanding block, it kept getting "stuck" on the finish. the finish was dry to the touch but felt different than usual. also the finish would leave permanent finger prints if i pressed my finger into it. i left the second coat to dry for 4 hours. still the same thing? now when i say cool i am talkin bout lousiana weather here. it probably was in the high 50's yesterday, humidity was probably pretty high though, didn't check the reading but i could tell.
so anyone else have problems like this? it says it is 100% dewaxed shellac
decided to leave it over night and all day today and try to resand tonight.
so anyone else have problems like this? it says it is 100% dewaxed shellac
decided to leave it over night and all day today and try to resand tonight.