Craig Johnson
Member
- Messages
- 113
- Location
- The Couv, Washington
Hi everyone.
I am just finishing my first outfeed table for my Steel City table saw.
The top is melamine and am curious what you guys use to cut the slots for the miter guage and what I should use to prevent chip out on the top.
I read a couple other posts on using tape to keep chip out to a minimum.
I am leaning toward my router for the job.
What say you?
I am just finishing my first outfeed table for my Steel City table saw.
The top is melamine and am curious what you guys use to cut the slots for the miter guage and what I should use to prevent chip out on the top.
I read a couple other posts on using tape to keep chip out to a minimum.
I am leaning toward my router for the job.
What say you?