Results 1 to 5 of 5

Thread: So close and yet so far...(Moak)

  1. #1
    Join Date
    Nov 2006
    Waterford, MI

    So close and yet so far...(Moak)

    Not mine, but apparently right around the corner. Too bad it wont fit in my space, budget, or fuse box. Sure is purty though.
    Link to my ongoing ClearVue DC Install on CV's site: http://www.gallery2.clearvuecyclones...s-Mini-CV1400/

  2. #2
    Join Date
    Jul 2008
    Brandon, MS
    Doug, They sure don't make 'em like they used to. That is a beauty. Unfortunately, the limitations apply to me too.

  3. #3
    Join Date
    Oct 2006
    Tokyo Japan
    Oh baby!

    They still make them like that but they run a tad bit more than $3500

    Super nice!
    The pessimist complains about the wind; the optimist expects it to change; the realist adjusts the sails.
    William Arthur Ward

  4. #4
    Nice looking machine.....I would consider it if I didn't already have a nice jointer. Not the with of that one but has 4 knives

  5. #5
    Join Date
    Dec 2006
    Floydada, Tx
    If it was closer I would go get it. Mine is ready for a boat anchor.

Similar Threads

  1. Not Done with it yet, but getting close....
    By Chuck Ellis in forum Turning Tool Questions and Show & Tell
    Replies: 8
    Last Post: 04-13-2015, 04:06 PM
  2. Getting Close
    By Al Launier in forum General Woodworking Q&A
    Replies: 13
    Last Post: 04-29-2013, 01:37 PM
  3. close enough
    By Stephen Bellinger in forum Lathe Project Showcase
    Replies: 18
    Last Post: 08-07-2012, 11:36 PM
  4. To Close for Comfort
    By Vaughn McMillan in forum General Woodworking Q&A
    Replies: 45
    Last Post: 02-21-2011, 01:41 AM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts