Stuart Ablett
Member
- Messages
- 15,917
- Location
- Tokyo Japan
Well, as we wind down the year here, things have been really hectic, long hours, and busy too, which is good if you are in retail, like we are, but I'm thinking ahead here to January, when things slow down, and I'll get some time in on the Dungeon renovation so I can shoehorn the SawStop in place. One thing I'm going to do is move the jointer from under the main work table in the center of the workshop, to the West wall, it will reside under the SCMS station, which will be attached to the wall, and on a metal rack. The way things are going to work out, with the new SCMS, the Hitachi unit with the rails on the side, it will all be much closer to the wall, so if I want to cut anything on the SCMS that is of any length, I'll be running into Big Blue on the left, and the lathe on the right. To solve this problem, I'm contemplating a SCMS station that would slide out, away from the wall, say 12", maybe less, maybe more?
If any of you have something like this, or have a link to something like it, I'd really like to hear about it.
Cheers!
If any of you have something like this, or have a link to something like it, I'd really like to hear about it.
Cheers!