Results 1 to 2 of 2

Thread: Nice surprise

  1. #1
    Join Date
    Nov 2006
    Oak Harbor Washington on Whidbey Island

    Nice surprise

    Dad gave me quite a few of his tools included were a Craftsman 8 HSS stacked dado & 3 carbide toothed wobble Dados one Rockwell & 2 Craftsman all 40 years old or older. The Rockwell is a 6 & not big enough for my saw the 2 Craftsman are about 7. I tried the one with the most teeth & surprise it works great nice flat bottom & clean square edges.
    "Forget the flat stuff slap something on the spinny thing and lets go, we're burning daylight" Bart Leetch
    "If it ain't round you may be a knuckle dragger""Turners drag their nuckles too, they just do it at a higher RPM"Bart

  2. #2
    Join Date
    Nov 2006
    Delton, Michigan
    good for you and hey i need to tell ya that spoke shave is gettin a work out on this bed and very glad to have it... thansk again bart, for all that we did last summer!
    If in Doubt, Build it Stout!
    One hand washes the other!
    Don't put off today till tomorrow!

Similar Threads

  1. A please surprise/gift
    By John Lannon in forum Neander Tool Questions and Show & Tell
    Replies: 1
    Last Post: 04-02-2012, 04:26 PM
  2. Nice surprise
    By Darren Wright in forum Off Topic Discussion
    Replies: 6
    Last Post: 11-03-2010, 03:16 PM
  3. Nice Surprise !!
    By Bob Gibson in forum Off Topic Discussion
    Replies: 6
    Last Post: 08-18-2010, 08:51 PM
  4. A bit of a surprise......
    By Stuart Ablett in forum General Woodturning Q&A
    Replies: 17
    Last Post: 02-11-2007, 04:02 AM
  5. I had a nice surprise last night
    By Bart Leetch in forum General Woodworking Q&A
    Replies: 5
    Last Post: 01-18-2007, 11:46 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts