Stuart Ablett
Member
- Messages
- 15,917
- Location
- Tokyo Japan
I'm putting the Arborite on the wing tables of the SCMS Saw Station and I'm wondering how you guys do it.
For example.........
On the faces, I use a laminate flush trim bit, but on any corner that is not at a 90, you cannot use the flush trim bit.
What I do is I try to cut and glue the piece as close as possible, then I use a file to bring it down flush. Is there a better way?
Just asking what you guys do, I learned most of this stuff a long time ago, and maybe there is a better way to do it now
Cheers!
For example.........
On the faces, I use a laminate flush trim bit, but on any corner that is not at a 90, you cannot use the flush trim bit.
What I do is I try to cut and glue the piece as close as possible, then I use a file to bring it down flush. Is there a better way?
Just asking what you guys do, I learned most of this stuff a long time ago, and maybe there is a better way to do it now
Cheers!