Jason Vanick
Member
- Messages
- 25
- Location
- Cary, IL
I'm getting ready to start designing my shop cabinets and I'd like to put ball bearing drawer slides in... however the price at rockler and borg are putting me off to this idea...
I do remember seeing somebody post about decent quality drawer slides for not too much $$$...
can anybody give me some recommendations or a link.
I want to make a bunch of drawers, probably 2" deep for hand tools, going all the way to 12"-14" deep for power tools at the bottom... probably a grand total of 40 or more drawers... so anything I can do to keep cost on the slides down I'm all ears.
Thanks!!!
-J
I do remember seeing somebody post about decent quality drawer slides for not too much $$$...
can anybody give me some recommendations or a link.
I want to make a bunch of drawers, probably 2" deep for hand tools, going all the way to 12"-14" deep for power tools at the bottom... probably a grand total of 40 or more drawers... so anything I can do to keep cost on the slides down I'm all ears.
Thanks!!!
-J