Ned Bulken
Member
- Messages
- 5,529
- Location
- Lakeport NY and/or the nearest hotel
After my winter making cutting boards, I had a bit of sawdust warming the floor of the shop... I also was stuck with a very small aisle in which to walk around with my benches pulled out from the wall after insulating the one wall last fall. Well, now that things are slowly getting warmer, at least to where I'm not going to get frostbite I decided it was time to clean up.
before:
and after an hour or so of sorting moving and even installing a sheet of plywood behind the bench (horizontally, I'm putting pegboard above it) I had this:
Still lots of clutter on the bench, but it is a relatively Organized clutter.
That section of the reflectix above the benches is where I'll be putting the pegboard. Should I mount it directly to the studs ,or should I put up a couple of 3/4 thick boards to stand them off of the wall just a bit?
Oh, and here's Why my shop is up on blocks instead of directly on grade:
before:
and after an hour or so of sorting moving and even installing a sheet of plywood behind the bench (horizontally, I'm putting pegboard above it) I had this:
Still lots of clutter on the bench, but it is a relatively Organized clutter.
That section of the reflectix above the benches is where I'll be putting the pegboard. Should I mount it directly to the studs ,or should I put up a couple of 3/4 thick boards to stand them off of the wall just a bit?
Oh, and here's Why my shop is up on blocks instead of directly on grade:
Last edited: