Kirk Constable
Member
- Messages
- 414
- Location
- Seguin, TX
... a little at a time.* Trying to get the small stuff out of the old shop* so I can get the big things out without tripping over it.* So here is the beginning of my new small (18x21), crooked, and humble shop.* Some of the things aren't where they'll end up, but just sitting there for now.* Dust collector is where it will be.* The compressor will be in the corner where the ladder is by the electric panel.* Edge sander will stay on that long wall, but probably more toward the middle.* I've just about decided to sit the table saw right in the middle, or at least far enough off the right wall (the wall with the edge sander) that I can walk by it comfortably.* I have a JET 18" bandsaw that's currently wired 115v, so it can go anywhere.* Jointer is also wired 115v and I haven't decided on that yet.* Powermatic mortiser will probably go on the long wall with the edge sander.* JET 1442 lathe I think will go on the short wall by the door, opposite the tall wall cabinet.* I have short cabinets to go above over that.* Table with the planer is now wheeled, as will be the table with the 16/32 sander.* I'll 'park' them somewhere when not in use, but I'm not sure where.* I really need the tablesaw sitting in place to finalize things.* I know a lot of folks have less space than this, but I'm cutting back quite a bit from the old shop (roughly half).* Anyhoo... it is what it as, and next Saturday the electrician will make me hot.*
Last edited: