Dan Mosley
Member
- Messages
- 1,169
- Location
- Palm Springs, Ca
I know we have discussed this in the past but i would like to seek some adivce here on what to buy for a outboard setup for my 16" Jet lathe.
I do not have the tap tools etc to make one and i dont think i want to drill into the lathe stand to attach a homemade type. Although i have seen some on here that look great.
1). I was wondering if anyone owns the outboard that jet sells and what you think of it ? I know its the kind that attaches and from what i have read it is a bit less stable then the kind that anchors down to the floor.
2). Anybody know where i can buy one on the web ?
3). Anybody know how large of diameter i would gain ?
Thanks Dan
I do not have the tap tools etc to make one and i dont think i want to drill into the lathe stand to attach a homemade type. Although i have seen some on here that look great.
1). I was wondering if anyone owns the outboard that jet sells and what you think of it ? I know its the kind that attaches and from what i have read it is a bit less stable then the kind that anchors down to the floor.
2). Anybody know where i can buy one on the web ?
3). Anybody know how large of diameter i would gain ?
Thanks Dan
Last edited: