Wood carversa

Al killian

Member
Messages
1,940
Location
Floydada, Tx
Any carvers intrested in carveing a peice of vinly board? I need to have a window header made. Im me if intrested. Mods, if you need this moved that is fine.:wave:
 
Wouldn't mind giving it a try, but I'm too far away and that's not the size of a dove though:dunno:

May I ask what for and why? I can think about at least two different ways of getting it if what you need is an unprutescible material for that window.
 
Toni, here is what I am looking for. The size would be around 10" heigth and 25" long and I will need two of them. Migth just go get a few carving tools and give it a try.
 

Attachments

  • 67306-01-500.jpg
    67306-01-500.jpg
    39.1 KB · Views: 16
That should be very easy to carve. Look at the tutorial I did on carving a fan and you should be able to extrapolate to that. I have some tutorials on carving a shell (different kinds of shells) there, also. Some of the techniques used there may help, also.

Mike
 
Top