I had always been disappointed with my light setup at the lathe. Until recently I had a 4ft. fluorescent light with 2 T8 daylight bulbs directly above the lathe and 3 100watt equivalent low voltage bulbs mounted in clip on fixtures from HD. It was adequate but I was constantly moving the clip ons or they would just slip and need to be readjusted. Then I stumbled upon this picture I had saved on my work computer.
this tip on Laymar Crafts. This site is packed full of great ideas, tips and articles. I had not thought of looking on that sight because frankly I had forgotten about it. (google is my friend) This new setup up gives me tons of light and also enabled me to improve my lighting elsewhere in the shop via the now unused 4ft. fixture.
air cleaner) Both blowers are plugged into a 6 outlet power strip which I can also plug my sanding and detailing tools into. I also added some washable filters at the return air areas in order to hopefully add to my dust cleaning. Once again, although it's not pretty, the craftsmanship isn't the best and it's made out of scrap this new tool works great and serves a great purpose.
If interested, you can view some more pics (including some oops!) of my light/fan box here