Results 1 to 2 of 2

Thread: raised panel tutorial, Table saw

  1. #1
    Join Date
    Dec 2008
    Location
    falcon heights, minnesota
    Posts
    5,605

    raised panel cutting on ts with jig part 1

    the first 2 pics are of the jig, the third is the board to be cut, the fourth is how the jig rides on the rip fence, the fifth is the board clamped in place, and the sixth is the blade raised and tilted to the desired angle. in this case, 14 degrees.
    Attached Thumbnails Attached Thumbnails IMG_0579.JPG   IMG_0578.JPG   IMG_0577.JPG   IMG_0576.JPG   IMG_0575.JPG  

    IMG_0580.JPG  
    benedictione omnes bene

    www.burroviejowoodworking.com

    check out my etsy store, buroviejowoodworking

  2. #2
    Join Date
    Dec 2008
    Location
    falcon heights, minnesota
    Posts
    5,605

    raised panel cutting on ts with jig part 2

    the first four pics are of the first 4 cuts, pic 5 is after returning the blade to 90 degrees (that's up and down larry ) and lowering the blade to about a little more than 1/4" or so, and the sixth pic is of the finished panel.

    i hope this helps you allen. it took longer to take the pics than to cut the panel.
    Attached Thumbnails Attached Thumbnails IMG_0581.JPG   IMG_0582.JPG   IMG_0583.JPG   IMG_0584.JPG   IMG_0585.JPG  

    IMG_0586.JPG  
    benedictione omnes bene

    www.burroviejowoodworking.com

    check out my etsy store, buroviejowoodworking

Similar Threads

  1. Raised Panel Doors in SketchUp
    By Dave Richards in forum Designs, Plans and Sketches
    Replies: 2
    Last Post: 12-31-2012, 03:42 AM
  2. Raised panel closeout
    By Dietrich Trenner in forum General Woodworking Q&A
    Replies: 0
    Last Post: 03-22-2012, 01:45 AM
  3. Raised Panel resized?
    By larry merlau in forum General Woodworking Q&A
    Replies: 28
    Last Post: 01-16-2011, 04:27 PM
  4. Replies: 7
    Last Post: 09-12-2009, 02:42 PM
  5. Raised Panel Door
    By Sean Wright in forum Flatwork Project Showcase
    Replies: 11
    Last Post: 03-29-2007, 12:16 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •