- Messages
- 7,986
- Location
- falcon heights, minnesota
raised panel cutting on ts with jig part 1
the first 2 pics are of the jig, the third is the board to be cut, the fourth is how the jig rides on the rip fence, the fifth is the board clamped in place, and the sixth is the blade raised and tilted to the desired angle. in this case, 14 degrees.
the first 2 pics are of the jig, the third is the board to be cut, the fourth is how the jig rides on the rip fence, the fifth is the board clamped in place, and the sixth is the blade raised and tilted to the desired angle. in this case, 14 degrees.