Chas Jones
Member
- Messages
- 958
- Location
- Cotswolds, UK
Yes..
Now, to change the battery, one would just pull the clock out from the case?
100mm (near enough 4" in your money)..What diameter is the face?
Finish is just Chestnuts Melamine wiped on with a cloth covered finger tip (stationary), rapid movement quick spread before it has time to build, followed by quick spin to burnish with old cotton hand towel...What is the finish?
Thanks Rob, the chunky craft stall look was precisely what I was trying to avoid. Don't know about your side of the pond but over here it would seem that a clock switches many turners into beading and embellishment mode...... That is certainly a great minimalist approach to a clock and it works so well. I am used to seeing clocks embedded in a chunck of wood but that wood border looks so much finer and refined. ...
Royall, I used Z-Poxy Epoxy Resin - (30 Minute) untreated wood, about 3/4sq" area.How was is attached to the base?
.....Dunno if I could to the 100mm part, though, since I don't have a metric lathe.
I just realized my Nova chucks have 100mm jaws, so I could probably pull it off after all. I guess you could say I have a hybrid setup.I think you could get Round to it if you tried Vaughn.