Rob Keeble
Member
- Messages
- 12,633
- Location
- GTA Ontario Canada
I have question regarding the handles of turning tools.
Does it make sense to turn some longer handles for ones turning tools given the relatively short handles that are shipped with the cheaper sets of tools?
If so how long would you make the handles?
I found the handles on my tools short on providing leverage but I would presume there is a balance here of some sort.
Probably over thinking this one again.
Does it make sense to turn some longer handles for ones turning tools given the relatively short handles that are shipped with the cheaper sets of tools?
If so how long would you make the handles?
I found the handles on my tools short on providing leverage but I would presume there is a balance here of some sort.
Probably over thinking this one again.