Tom Baugues
Member
- Messages
- 2,794
- Location
- Lafayette, Indiana
I've gotten my lathe out of storage and am getting back to making some projects. It's been a few years since I've made anything and wanted to ask what type of glue you all use nowdays. I used to use a two part epoxy but that always seemed to be a mess and always got inside the tubes and was hard to remove. Is there a better way nowdays? I tried CA also but it didn't seem to hold as well as epoxy. How do you keep it from getting inside the tubes? I was told once that if I put the glue on the tube first then it would not coat the inside of the block evenly. So...what is the answer?
Tom
Tom