Mike Grimm
Member
- Messages
- 159
I'm getting ready to build our new dining room table set, its the trestle table that was featured on the cover of the Woodsmith magazine (VOL.31/No. 181, couple months back) and the top is made of a single piece of 3/4" cherry plywood.
I've never had good luck with the cross cuts on plywood not chipping out, so, was wondering if anyone knew of a really good blade I could purchase and stick in my table saw for this particular piece of wood?
Thanks in advance!
I've never had good luck with the cross cuts on plywood not chipping out, so, was wondering if anyone knew of a really good blade I could purchase and stick in my table saw for this particular piece of wood?
Thanks in advance!