Doug Miller
Member
- Messages
- 277
- Location
- Hardinsburg, KY
Pine that that is. This is a piece I turned a while back but am just not getting finished. Roughly 6 1/2" wide x 3 1/2" tall. 1/8" or less thick from top to bottom. In fact, the center of the bottom will let light through without any problem. This is one of those turnings that if I still had a bunch of DO, I would have done the multiple soak and dry cycle thing ala Ron Kent. Finish is several coats of Seal-A-Cell followed by several coats of Arm-R-Seal. This is another case to show us all that too much under the top coat is detrimental to the finial finish. The buffing wheels pulled the top coat right off. I had to sand it back and start again. No more than one coat of the sealer for me, unless it is going to be the only finish, from now on.
Questions and comments always welcome.
Questions and comments always welcome.