Travis Porter
Member
- Messages
- 292
- Location
- Wake Forest, NC
Here are a few pics of my shop before my last "reorganization". My shop is 24 x 32 (outside to outside), with concrete floors, 10 ft ceilings, a sink with water (used to have hot, have to fix a pipe underground), and a heat pump to keep it nice and toasty.
First, a shot as you come in the door.
Here is where I used to have my clamps and still have my compressor
Here is the sink before and after. Took me 2 years to finally finish the doors and drawers. Got embarassed when I originally took the pictures and finally took the time to finish it.
My tablesaw that likes to loosen the arbor nut (didn't get to go out and play tonight as I played Daddy.
Belt disk combo. Kind of regret buying this now. Wish I had just gotten an oscillating belt instead.
Where my lumber rack used to be. This turned out to be a pain as I could not store much wood.
The plywood rack holds about 10 sheets
My old drill press (before my recent upgrade)
A few more before pics to post before I start posting some now pics. Thanks for looking, comments and feedback welcome.
First, a shot as you come in the door.
Here is where I used to have my clamps and still have my compressor
Here is the sink before and after. Took me 2 years to finally finish the doors and drawers. Got embarassed when I originally took the pictures and finally took the time to finish it.
My tablesaw that likes to loosen the arbor nut (didn't get to go out and play tonight as I played Daddy.
Belt disk combo. Kind of regret buying this now. Wish I had just gotten an oscillating belt instead.
Where my lumber rack used to be. This turned out to be a pain as I could not store much wood.
The plywood rack holds about 10 sheets
My old drill press (before my recent upgrade)
A few more before pics to post before I start posting some now pics. Thanks for looking, comments and feedback welcome.