Syd Lorandeau
Member
- Messages
- 29
- Location
- Claremont, NH
Hi All,
In the past I have made some cutting boards or serving trays but they have been round so I go from the band saw to the lathe and finish them up.
Well when turning them my rounding over was like a 1/2" or better taper into the board. Well I moved on the different shapes and LOML does not like the round over I am now putting on them with the router as she likes the slim edge.
Does anyone have any ideas as to how I can do this short of one lot of sanding??? Hope this is somewhat clear but I went from round to this.
Thanks, SydC:\Users\Syd\Pictures\Cutting Boards\DSC05026.JPG
In the past I have made some cutting boards or serving trays but they have been round so I go from the band saw to the lathe and finish them up.
Well when turning them my rounding over was like a 1/2" or better taper into the board. Well I moved on the different shapes and LOML does not like the round over I am now putting on them with the router as she likes the slim edge.
Does anyone have any ideas as to how I can do this short of one lot of sanding??? Hope this is somewhat clear but I went from round to this.
Thanks, SydC:\Users\Syd\Pictures\Cutting Boards\DSC05026.JPG