Don't want to brag, but...
About two years ago, LOML got tired of shutting down all other projects just to get a project finished, so we tacked on a 12x20' finishing room to the back of our shop. There is a door to/from the shop and another door to/from outside for taking things out of the room without moving back through the shop and taking the risk of nicking something.
First is the north 12' wall, left-hand side as you look at it. Shop rags and a wall-mount hanger for 5 gallons of lacquer thinner. Note the HVLP guns hanging from the wall.
Next, the north 12' wall, right-hand side, with a roll of brown paper hanging on the wall.
Exhaust fan high on the wall
Reel for sprayer air tubing above a work/designing bench - the PVC for the air gun comes through the wall - about a 25' run from the 5hp compressor.
Lower cabinets -right
Lower cabinets - left
Corner cabinet on south 12' wall for storing my craft-show stuff.
Tall cabinet where we store our plaque blanks - outside door to the right, door to the shop on the left
And last but not least, door into the shop.
We have 3 4-foot 2-bulb fluorescent lights, plus two west-facing skylights in the room. The door from the shop is a steel entry door with some good weatherstripping on it, so we don't get a lot of dust into the finishing room (if we remember to keep the door closed). Floor is concrete with rubber interlocking floor matting. Hubby put plywood on the wall above the workbench on the north wall above the cabinets so he could hang his HVLP guns, etc. up there. Workbench is made of some maple gym flooring we were given (but that's a whole 'nother story).
Nancy