Doug Miller
Member
- Messages
- 277
- Location
- Hardinsburg, KY
I spend most of my time in Lathe Land but have a problem with my radial arm saw. DeWalt/Black&Decker radial arm saw. Quit working all of a sudden. Changed the start capacitor with no success. Guy at the B&D store was pretty sure that I would find that the switch was bad. I've now pulled it out of the saw. One button on, one button off. Four poles on the back side labeled L1, L2, 1, and 2. Any suggestions on how to test this switch? I can put it back into the saw if necessary.