Mark Pruitt
Member
- Messages
- 49
- Location
- Leeds, AL
Here is a piece that I turned from a 2 x 8 x 8 piece of Mora. It is a hard, dense wood that takes finish well. I used Teak Oil for finish; it required only two coats. The pedestal is Beech; it required an additional coat of finish. I Beall buffed the piece as well. Comments welcome.
Here you can see where a bit of the sapwood was in this block...
...and here is the inside.
Here you can see where a bit of the sapwood was in this block...
...and here is the inside.