Bill McQueen
Member
- Messages
- 140
- Location
- Lincoln AR
I've made a jig to make flutes in my bowls and stuff, but here is my problem. I keep burning the wood. I have a speed reducer I use on my shaft driver cutter but it stills burns it. I am using a trim router which will only take about a 1/8 bit.
Am I destined to use a larger router just can't get the speed slow enough. I put a lot of work into this set up I hate to 13 it and do it by hand.
Thanks ,
Am I destined to use a larger router just can't get the speed slow enough. I put a lot of work into this set up I hate to 13 it and do it by hand.
Thanks ,