Jeff Horton
Member
- Messages
- 4,272
- Location
- The Heart of Dixie
Not a big fan of routers and rarely use mine. I have one of those Delta Router/Shaper units I have been using but the table is pretty small. So I have this large extension table on the Unisaw and realizing that I should just mount a router in there.
Since I am not a tool junkie like some of you guys. I don't keep up with all that is out there and the options. So what is a cheap way to mount the router in the plywood and it be quick to remove? I assume a router plate? But I am looking for something cheap,I have a shaper and I just not going to spend tons of money on this. It will be set up with a roundover bit and a pattern bit and that is probably it.
Since I am not a tool junkie like some of you guys. I don't keep up with all that is out there and the options. So what is a cheap way to mount the router in the plywood and it be quick to remove? I assume a router plate? But I am looking for something cheap,I have a shaper and I just not going to spend tons of money on this. It will be set up with a roundover bit and a pattern bit and that is probably it.
Last edited: