allen levine
Member
- Messages
- 12,370
- Location
- new york city burbs
another past impusle buy, 9.99 harbor freight 5 pc raised panel set of bits.
Needed a 1/2 inch collet, so I took an old walmart computer stand, particle board/laminate, that was tossed, cut a hole in a side wall, mounted the dewalt router I have with 1/2 collet.
Raised panel came out easy. Stiles came out easy enough, but making rails to match and fit easily, there was a problem.
Is there a secret to setting heights on bits so they match up each time or is it just eyeballing till it gets right?(my set came out too thin, but its the first one I got to actually fit correctly)
Needed a 1/2 inch collet, so I took an old walmart computer stand, particle board/laminate, that was tossed, cut a hole in a side wall, mounted the dewalt router I have with 1/2 collet.
Raised panel came out easy. Stiles came out easy enough, but making rails to match and fit easily, there was a problem.
Is there a secret to setting heights on bits so they match up each time or is it just eyeballing till it gets right?(my set came out too thin, but its the first one I got to actually fit correctly)