Dan Mosley
Member
- Messages
- 1,169
- Location
- Palm Springs, Ca
Finally got the compressor i bought out of the truck today with some help of a couple kids assisting. It weighs alot but i had cut some 6x6's for a footing and we set it down on the beams. I then bolted it down on the beams because the day i bought it the owner had it strapped down on a pallet and it is a bit more weighted to one side it seemed and could tip very easy (see pic below).
Questions:[/B
1). When we took it out of the truck it had been laying down and alot of oil started flowing out of the air filter. It soon stopped but i am assuming that i should replace the oil and clean up the airflilter with gas. The label says Synthetic Compressor Oil - Where do you usually buy this type of oil ?
2). I noticed it has a regulator (pic below) but is missing a water trap but im sure i have one around the garage. Anybody think of anything else I should do?
3). Looked online and i am unable to find the Manual for the Model T-30 so ill try to contact Ingersoll in a day or so and see if i can get one. Unless anyone knows a better way ?
Thanks in advance for any suggestions..........Dan
Questions:[/B
1). When we took it out of the truck it had been laying down and alot of oil started flowing out of the air filter. It soon stopped but i am assuming that i should replace the oil and clean up the airflilter with gas. The label says Synthetic Compressor Oil - Where do you usually buy this type of oil ?
2). I noticed it has a regulator (pic below) but is missing a water trap but im sure i have one around the garage. Anybody think of anything else I should do?
3). Looked online and i am unable to find the Manual for the Model T-30 so ill try to contact Ingersoll in a day or so and see if i can get one. Unless anyone knows a better way ?
Thanks in advance for any suggestions..........Dan
Attachments
Last edited: