Dan Mooney
Member
- Messages
- 1,920
- Location
- Portland, Oregon
The Crank handle for raising and lowering the table on my drill press broke.
So i stopped by my local metal monger and found this 4"x4"x1" piece of aluminum.
A little drilling a little cutting, a little spinning, and a couple hours later the drill dress is back in order.
I wanted to make it a little longer for more leverage, but it would hit the table.
I took Larry's advice from his tag line, and built it Stout!
So i stopped by my local metal monger and found this 4"x4"x1" piece of aluminum.
A little drilling a little cutting, a little spinning, and a couple hours later the drill dress is back in order.
I wanted to make it a little longer for more leverage, but it would hit the table.
I took Larry's advice from his tag line, and built it Stout!