Bill McQueen
Member
- Messages
- 140
- Location
- Lincoln AR
I want to cut a grove in a piece of 3/4 Melamine covered board, I'll use either a table saw or router bit.
Is there a way beside scribing a line to keep from breaking little chips out of the edges of the cut?
There well be a aluminum track in the slot but I don't want little chips showing on either side of the cut.
Thanks
Is there a way beside scribing a line to keep from breaking little chips out of the edges of the cut?
There well be a aluminum track in the slot but I don't want little chips showing on either side of the cut.
Thanks