Results 1 to 4 of 4

Thread: Name plate for sept-son's Desk !!!

  1. #1

    Name plate for sept-son's Desk !!!

    I don't know if this the right place , but here go's anyway . Made this for my septson's desk which he works at a Harley-Davidson Dealership which will set on his desk.............I'll put the finishing touches on it later ..the name plate came from Steve Good's pattern printer and the bike came from his site also.......Marshall
    Attached Thumbnails Attached Thumbnails SHANE'S NAME PLATE2 (Small).JPG  
    Last edited by Marshall Border; 10-25-2009 at 02:21 AM.
    Usually Busier than a Cat In A sand Box : Arkansas Red Wolf & Razorbacks Fan

  2. #2
    Join Date
    Oct 2006
    somewhere east of Queen Creek, AZ - South East of Phoenix
    Cool Marshal, now tell him that you'll pay him commison on all order he gets from his co-workers.
    "There’s a lot of work being done today that doesn’t have any soul in it. The technique may be the utmost perfection, yet it is lifeless. It doesn’t have a soul. I hope my furniture has a soul to it." - Sam Maloof
    The Pessimist complains about the wind; The Optimist expects it to change;The Realist adjusts the sails.~ William Arthur Ward

  3. #3
    Join Date
    Nov 2006
    Mountain Home, Arkansas
    Neat. I'm sure he will treasure.
    "Folks is funny critters."

    Think for yourselves and let others enjoy the privilege to do so, too. ~Voltaire

  4. #4
    Join Date
    Jul 2009
    Amherst, New Hampshire
    Thats pretty cool. I downloaded his pattern and key chain maker. Haven't made anything yet.
    Faith, Hope & Charity

Similar Threads

  1. Leo's Workshop - Sept 22 2014 - Part one
    By Leo Voisine in forum Programming, Troubleshooting, and Q&A
    Replies: 11
    Last Post: 09-24-2014, 09:50 PM
  2. Lee Valley Sept 13th Announcement
    By glenn bradley in forum General Woodworking Q&A
    Replies: 3
    Last Post: 09-14-2014, 01:08 PM
  3. 1995 Sept. 11
    By Dave Hawksford in forum Off Topic Discussion
    Replies: 4
    Last Post: 05-04-2013, 01:25 AM
  4. chuck plate/face plate
    By allen levine in forum General Woodturning Q&A
    Replies: 40
    Last Post: 10-27-2009, 05:17 PM
  5. Asking for a little help here....... (Update Sept. 6th)
    By Stuart Ablett in forum Off Topic Discussion
    Replies: 54
    Last Post: 09-06-2009, 03:22 PM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts