Hi everyone
Awhile ago I built the WOOD magazine cyclone DC. It uses a cartridge filter from a truck I think as the output filter and a garbage can as the collector for the chips.
I've been having problems with the filter/lines getting packed with chips, the cyclone isn't doing its thing.
I think it is because I have a bad seal between the garbage can top and the can itself, therefore air is flowing into the system and causing the chips to go up into the exhaust line.
This is the second time it has happened in the past three months, all of a sudden I notice that the DC isn't sucking, which by the way sucks, and I"ve got to tear it apart, vacuum out the filter and put it back together.
I bought some backer bead over the weekend, split it and used caulk to attach it to the edge of the can to try to make a better seal.
I can't find any other good gasket material at the borgs, I was using the peel and stick window gasket stuff but I think that was too thin, or not robust enough to last over time.
Any suggestions? I am thinking about getting some of that "flat twine" plastic wrap and just sealing the lip once the can top is on, and cutting it off when I need to empty.
I'm thinking of one of those cardboard type containers with the steel locking ring on the top but I don't even know what they are called so I can start searching for them!
Jay
Awhile ago I built the WOOD magazine cyclone DC. It uses a cartridge filter from a truck I think as the output filter and a garbage can as the collector for the chips.
I've been having problems with the filter/lines getting packed with chips, the cyclone isn't doing its thing.
I think it is because I have a bad seal between the garbage can top and the can itself, therefore air is flowing into the system and causing the chips to go up into the exhaust line.
This is the second time it has happened in the past three months, all of a sudden I notice that the DC isn't sucking, which by the way sucks, and I"ve got to tear it apart, vacuum out the filter and put it back together.
I bought some backer bead over the weekend, split it and used caulk to attach it to the edge of the can to try to make a better seal.
I can't find any other good gasket material at the borgs, I was using the peel and stick window gasket stuff but I think that was too thin, or not robust enough to last over time.
Any suggestions? I am thinking about getting some of that "flat twine" plastic wrap and just sealing the lip once the can top is on, and cutting it off when I need to empty.
I'm thinking of one of those cardboard type containers with the steel locking ring on the top but I don't even know what they are called so I can start searching for them!
Jay