Rick Prosser
Member
- Messages
- 377
- Location
- Midlands of South Carolina
Now that the tractor shed is up, I need to start storing stuff.
I have two attachments for the front end loader. I have 3 (soon to be 4) rear attachments for the tractor.
In order to save space, I was thinking that I could store the FEL bucket and grapple on a table, and put a couple of rear attachments under them. The front end loader can hook up to the skid steer implements and drop them on the table without issue - I think
The table would need to be real sturdy - to hold around 1000 pounds fully loaded, and get banged around somewhat. 12 ft long, maybe 4 ft deep and 3-4 ft high.
Is this a bad idea?
Any good table design suggestions? I am thinking 4x4 legs and 2x4 edgewise on top - similar to workbench, but space between the 2x4s so dirt can fall thru.
I have two attachments for the front end loader. I have 3 (soon to be 4) rear attachments for the tractor.
In order to save space, I was thinking that I could store the FEL bucket and grapple on a table, and put a couple of rear attachments under them. The front end loader can hook up to the skid steer implements and drop them on the table without issue - I think
The table would need to be real sturdy - to hold around 1000 pounds fully loaded, and get banged around somewhat. 12 ft long, maybe 4 ft deep and 3-4 ft high.
Is this a bad idea?
Any good table design suggestions? I am thinking 4x4 legs and 2x4 edgewise on top - similar to workbench, but space between the 2x4s so dirt can fall thru.
Last edited: