Jack Vines
Member
- Messages
- 10
Even though I didn't need it, this hundred-year-old Avey was just too well-made to see it go for scrap. The three-speed Mopar transmission addition is interesting, but will have to go. It does give twelve speeds forward and four in reverse.
1. Found the patent info http://www.freepatentsonline.com/1388876.pdf Does anyone have any literature or a link to any more info about Avey and/or the Cincinnati Pulley Machine Co.?
2. This was originally a line shaft drive. What horsepower would be optimum for a #2MT machine?
3. Anyone have surplus 2" flat belt drive/driven pulleys?
4. What are the max/min drill diameters for #2MT? Most I have are between 1/2" and 3/4". Where to look for surplus bits larger and smaller?
thnx, jack vines
1. Found the patent info http://www.freepatentsonline.com/1388876.pdf Does anyone have any literature or a link to any more info about Avey and/or the Cincinnati Pulley Machine Co.?
2. This was originally a line shaft drive. What horsepower would be optimum for a #2MT machine?
3. Anyone have surplus 2" flat belt drive/driven pulleys?
4. What are the max/min drill diameters for #2MT? Most I have are between 1/2" and 3/4". Where to look for surplus bits larger and smaller?
thnx, jack vines