Mack Cameron
In Memorium
- Messages
- 876
Lathe = Model 1460, Stand = Model 1463, together they make up the Delta Rockwell 12" X 37" Wood Turning Lathe Model 46-305. It's D. of B. is Jan. '48, verified with Delta by the serial # 61-5066. New Original Equipment bearings replaced early '08.
View attachment 39985
This is a pic of the day it was put into operation in my basement workshop. It is covered in pen shavings at this time but when dusted off would look like new again.
Right angle tool support, 4 step motor pulley, 3" & 6" face plates, 4", 12", & 24" tool rests, floor stand for outboard tool rest, spindle steady, spur centre, cup centre etc. etc.
No turning tools. Asking $700.00
View attachment 39986
View attachment 39987
Motor specs for any interested parties!
View attachment 39985
This is a pic of the day it was put into operation in my basement workshop. It is covered in pen shavings at this time but when dusted off would look like new again.
Right angle tool support, 4 step motor pulley, 3" & 6" face plates, 4", 12", & 24" tool rests, floor stand for outboard tool rest, spindle steady, spur centre, cup centre etc. etc.
No turning tools. Asking $700.00
View attachment 39986
View attachment 39987
Motor specs for any interested parties!
been spinnun stuff for along time...