allen levine
Member
- Messages
- 12,368
- Location
- new york city burbs
Been doing alot of bevel and mitre cuts, and today the cover stopped going up all the way, had to hold it up so it didnt interfere with cuts.
I just spent approx one hour with my son taking off cover and looking over all the parts, and could not figure it out unless something fell off.
The flat rod that pushes it on machine itself looks completely intact and is moving freely and seems to be moving correct distance.
The piece on cover seems to be too far away and contact is not made until halfway down, therefore the cover doesnt lift enough.
Any suggestions?
(I need the blade cover, removing it is not an option for me)
I just spent approx one hour with my son taking off cover and looking over all the parts, and could not figure it out unless something fell off.
The flat rod that pushes it on machine itself looks completely intact and is moving freely and seems to be moving correct distance.
The piece on cover seems to be too far away and contact is not made until halfway down, therefore the cover doesnt lift enough.
Any suggestions?
(I need the blade cover, removing it is not an option for me)