- Messages
- 36,134
- Location
- ABQ NM
Here are two of three cutting boards I've made recently with a lot of help from Pete Simmons and his laser inlay skills. I had someone inquire about buying a similar kokopelli board, but I didn't have one in stock, so we made three. They are made from curly maple, walnut, cherry, and purple heart, with mahogany inlays. Sanded to 600 grit and soaked with my standard plain ol' mineral oil. A quick shot of Howard Feed N Wax, and they were done. Sorry the pics aren't the best...I was in a hurry and didn't get out the photo rig.
We did one left-hand model and two right-hand models. The left-hand one sold, so the remaining two will travel to the shows with me until they're sold. I just planed, cut, glued, planed, and sanded some boards. Pete did all the hard parts by handling the inlay. Thanks again, Pete.
We did one left-hand model and two right-hand models. The left-hand one sold, so the remaining two will travel to the shows with me until they're sold. I just planed, cut, glued, planed, and sanded some boards. Pete did all the hard parts by handling the inlay. Thanks again, Pete.