Tom Pashkevich
Member
- Messages
- 1
Hello,
My first post, looking to expand my woodworking vocabulary from the
community.I'm using a craftsman 10 inch table saw w 5/8 arbor.I have a couple of projects going on and I need to make some box joints, so I just
purchased the Freud SD 208.Uptil now my only experience has been with
a wobbly dado.
A couple of questions about the SD208- My set came with left/right
outside blades,3) chippers, 3) 1/16 spacers,8) shims.
My basic question, after reading the setup instructions, I'm still not
sure how to position the chippers when stacking together.From the
instructions it is kind of vague.Is it just a matter as long as the teeth
of the chippers and the outside blades are not aligned?Something like
this, a picture of one stacked would really make a difference.
Stacking two of the chippers and looking at it together there's something that doesn't look right about it.
Thanks in advance
My first post, looking to expand my woodworking vocabulary from the
community.I'm using a craftsman 10 inch table saw w 5/8 arbor.I have a couple of projects going on and I need to make some box joints, so I just
purchased the Freud SD 208.Uptil now my only experience has been with
a wobbly dado.
A couple of questions about the SD208- My set came with left/right
outside blades,3) chippers, 3) 1/16 spacers,8) shims.
My basic question, after reading the setup instructions, I'm still not
sure how to position the chippers when stacking together.From the
instructions it is kind of vague.Is it just a matter as long as the teeth
of the chippers and the outside blades are not aligned?Something like
this, a picture of one stacked would really make a difference.
Stacking two of the chippers and looking at it together there's something that doesn't look right about it.
Thanks in advance