Results 1 to 3 of 3

Thread: Been working on a few pepper mills.

  1. #1
    Join Date
    Dec 2007
    Tellico Plains, Tennessee

    Been working on a few pepper mills.

    I got a few laminated pepper mills blanks earlier this month and thought I would do a few of them... I'm talking to the mfgr about maybe being a reseller in my area... we'll see how that goes in time... Meantime, I've worked up part of the blanks... these are not finished, they have a coat of sanding sealer, but no finish yet... also have to put the guts in them after they are finished...

    They range from about 7 1/2" to 10 1/2" high.. the blanks were all 2 1/2 square which is a little smaller than I like to start, but seems to have worked okay..
    Attached Thumbnails Attached Thumbnails pm 011.JPG   pm 013.JPG   pm 014.JPG   pm 015.JPG   pm 018.JPG  

    Tellico Plains, TN
    My parents taught me to respect my elders, but it's getting harder and harder to find any.
    If you go looking for trouble, it will usually find you.

  2. #2
    Join Date
    Oct 2006
    ABQ NM
    Nice job, Chuck. Those are some cool-looking blanks. I really like colors in #3 and #4 in particular.
    When the going gets weird, the weird turn pro. - Hunter S. Thompson
    When the weird get going, they start their own forum. - Vaughn McMillan

  3. #3
    Join Date
    Mar 2008
    bethel springs TN, but was born and raised in north east PA
    Chuck glade to see you back at it. There gonna be some really cool mills. If you don't mind me asking where ya getting them blanks? I can see me using something like them to make my finals and bases.

Similar Threads

  1. new run of pepper mills
    By Dan Noren in forum Lathe Project Showcase
    Replies: 14
    Last Post: 10-06-2014, 05:42 PM
  2. And a few pepper mills
    By Chuck Ellis in forum Lathe Project Showcase
    Replies: 6
    Last Post: 11-26-2012, 11:36 PM
  3. Pepper or Salt mills
    By Dennis Kranz in forum General Woodturning Q&A
    Replies: 5
    Last Post: 05-15-2012, 06:59 PM
  4. pepper mills
    By larry merlau in forum Turning Tool Questions and Show & Tell
    Replies: 17
    Last Post: 06-21-2009, 04:55 AM
  5. Pepper and Salt and Pepper Mills
    By Vaughn McMillan in forum Lathe Project Showcase
    Replies: 12
    Last Post: 12-25-2008, 04:46 AM


Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts