Brad Nailer

Messages
33
Looking for some upgrade advice. I purchased a craftman electric brad nailer from Sears. For the miost part, it works ok. Occasionally, however, it will seem to deflect and exit narrow pieces at an angle damaging the board. Just wondering if this is an issue with all nailers or if I should consider going with a pneumatic? I am consdiering a comporessor for finishing so it may make sense to do both if the results will likley be better.

thanks in advance

Sal
 
never used an electric nailer:eek:
any nail can "blow-out".
a heavier guage wire will be less likely to blow-out.
get air......you`ll never regret it!
 
Top