- Messages
- 16,585
- Location
- Reno NV
So, Not sure this rates being in a 'showcase', but since I made it, thought I would post a picture.
All made out of 100% borg kilndried 2x4's... (well, except for the bottom of the seed tray, that's borg 1/4" ply)
Jointed and planed flat, and glued up. Joinery on the apron is rudimentary at best, just some dowels AND pocket holes. This project let me to ask the question 'how do you make your mortises'... I think I should have used MxT instead, but what the heck...
2 parts, the table, and the seed try and light stand.
No finish on the table, Seed tray is coated in fiberglass polyester resin, for water proofing..
The light is a 4 bulb SunBlaze high output flourescent.
All made out of 100% borg kilndried 2x4's... (well, except for the bottom of the seed tray, that's borg 1/4" ply)
Jointed and planed flat, and glued up. Joinery on the apron is rudimentary at best, just some dowels AND pocket holes. This project let me to ask the question 'how do you make your mortises'... I think I should have used MxT instead, but what the heck...
2 parts, the table, and the seed try and light stand.
No finish on the table, Seed tray is coated in fiberglass polyester resin, for water proofing..
The light is a 4 bulb SunBlaze high output flourescent.