Julio Navarro
Member
- Messages
- 281
- Location
- Tampa
I am building a new smaller more versitle router table. I bought the Rousseou plate and I am about to router out the hole for it but I cant decide where it should go in the table top.
The top is 28" wide x 19" deep, the plate is 9x12. Should it go exactly centered?
How have you guys placed the plate?
This is the last peice of shop equipment(besides the lathe base) I need to make and I want it to be just right.
Thanks all.
The top is 28" wide x 19" deep, the plate is 9x12. Should it go exactly centered?
How have you guys placed the plate?
This is the last peice of shop equipment(besides the lathe base) I need to make and I want it to be just right.
Thanks all.